Food & Beverage

Home Industries Food & Beverage BevPure Filter Cartridges

BevPure Filter Cartridges

Single-layer PES Membrane · Sterilizing Grade

BevPure^? Filter Cartridges are specially designed to provide reliable sterilizing filtration at the most economical costs. Hydrophilic PES membrane filters require no pre-wetting and are ready to use. This filter is recommended for the sterile filtration of a wide range of liquids e.g. diluting water and beverages.

Features and Benefits

Inherent hydrophilic PES membrane
Each filter is individually Integrity Tested prior to factory dispatch
Bacterial Challenge Test with B.diminuta bacteria
Complies with Food Contact Regulations: FDA 21CFR177-182 and 1935/2004 EC

Specification
Performance
Ordering Information

Materials of Construction

Filter Medium	Single-Layer PES Membrane
Cage / Support	Polypropylene
Core / End Caps	Polypropylene

Operating Conditions

Max. Temperature	80°C
Max. Differential Pressure	4.0 bar / 21°C (forward flow) 2.4 bar / 70°C (forward flow)
Bubble Point	BP: >0.34 MPa (water), 0.22 μm BP: > 0.22 MPa(water), 0.45 μm
Diffusion Flow	DF: < 30 ml/min/10"@ 0.25Mpa(water), 0.22μm DF: < 28 ml/min/10"@ 0.16Mpa(water), 0.45 μm
Steam Sterilization (Saturated Steam)	≥200 cycles (135°C/30 min @ Max.Differential Pressure of 0.3 bar)
Hot Water Sterilization	85°C/30 min @ Max. Differential Pressure of 2 bar
Cleaning Solution	2% NaOH Solution @ ≤65°C
Effective Filtration Area	0.58m2 / 10 inch

Reliable Microbiological Control

The primary purpose of this membrane filter cartridge in beverage filtration is to effectively remove product spoiling microorganisms

Typical Log Reduction Value(LRV)
	B.diminuta	Lactobaccilus Brevis	Sasharomyces Cerevisiae
0.1μm	> 7/cm2	N/A	N/A
0.2μm	> 7/cm2	N/A	N/A
0.45μm	N/A	> 7/cm2	N/A
0.65μm	N/A	> 4/cm2	> 7/cm2
1.2μm	N/A	N/A	> 7/cm2

Flow Rate Characteristics

Ordering Information

	-R	Removal Ratings	End Cap	Nominal Length	Seal Material	-F
BP	Blank	0010=0.1μm	DOE=Double Open End	05= 5"	S=Slilicone
[Ф69]		0022=0.22μm	HTC=222 O-ring/Flat (PBT Insert)	10= 10"	E=EPDM
		0045=0.45μm	HTF=222 O-ring/Fin (PBT Insert)	20= 20"	V=Viton
			HSF=226 O-ring/Fin (PBT Insert)	30= 30"
			SSF=226 O-ring/Fin (SS Insert)	40= 40"
			SSC=226 O-ring/Flat (SS Insert)
			STF=222 O-ring/Fin (SS Insert, 3 Tabs)